Q51. An engineer is trying to identify if radar has impacted the wireless network at a customer site. When using the controller GUI, which dashboard in the Monitor section presents this information?
A. 802.11a/n - Air Quality Reports
B. Clean Air - Worst Air Quality Report
C. 802.11b/g/n - Interfering Devices
D. Statistics - Mobility Statistics
Q52. A help desk ticket states that a wireless access point has not joined its controller and is flashing rapidly. How can the help desk administer the access point with the default settings?
Q53. What three components are required to configure Mobility Group Members between Wireless LAN Controllers? (Choose three.)
A. Controller Management IP Address
B. Controller Virtual IP Address
C. Controller Multicast IP Address
D. Controller MAC Address
E. Controller Mobility Group Name
F. Controller AP Management IP Address
G. Controller RF Group Name
Q54. An engineer is conducting an active survey for indoor coverage in a warehouse. The warehouse has long aisles with racks that extend to the ceiling. Which antenna type has a radiation pattern that is suited to provide coverage in each aisle?
Q55. A customer is using the access point GUI to upgrade the software on an autonomous access point to convert it to a lightweight access point. Which two transfer protocols are valid for conducting this transfer from the WLC? (Choose two.)
Q56. When using a Cisco WLC version 7.0 with a default configuration, how is a remote management HTTPS access connection secured?
A. The Cisco WLC uses a pre-shared key to authenticate the user, which limits the number of potential users that can access the controller.
B. The Cisco WLC generates its own local web administration SSL certificate and automatically applies it to the GUI.
C. The Cisco WLC uses a CA certificate for SSL access.
D. The Cisco WLC uses HTTPS to secure the HTTP session via a preconfigured password that generates a certificate for each session.
Q57. What must be done for Cisco WLC and Cisco WCS to communicate?
A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS.
B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC.
C. The identity certificate of the Cisco WLC must be added to the Cisco WCS.
D. The Cisco WLC and Cisco WCS must exchange identity certificates.
Q58. You have an organization that has a growing number of standalone APs. You would like to migrate to lightweight APs and manage them through Cisco WCS.
Which software platform allows you to make this migration?
A. The enterprise version of Cisco WCS allows this migration and provides the most flexibility in the number of APs supported.
B. CiscoWorks WLSE is the only management platform that allows this migration, but it is limited to 500 APs.
C. You can migrate your network to Cisco WCS single server with the CiscoWorks WLSE upgrade software upgrade.
D. You can migrate the network by using either the single server or enterprise software platforms, both using the CiscoWorks WLSE upgrade software upgrade.
Q59. A wireless engineer has been asked to plan a deployment covering the aisles of a warehouse with optimal coverage while bleeding RF across aisles. Which antenna type provides the necessary coverage?
D. parabolic dish
Q60. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved?
C. console port
D. service port
To know more about the 200-355, click here.